SBM601HR-230v for only $888.36 - Steambrite's price on the Water Heaters High Pressure - SBM601HR-230v extractor, Equipmentcarpet cleaning equipment, Equipment flood restoration, Equipment carpet cleaning machine,

Clean Storm In Line Compact 2000 Watt Heater for Carpet Cleaning Equipment 230- 240volts for international use

Features:

• Ultra Compact And Easy To Carry Design
• 4 Rubber Feet On Bottom Plus 4 Rubber Feet On Side
  
• Rust free Aluminum Case with all Stainless Steel and Brass Parts
  
• 600 psi Safety Pressure Relief Valve
  
• 20 amp push button safety breaker
  
• Stainless steel On/Off Switch
  
• Easy Access To Inside For Service
  
• Five Foot 3000 psi In-Bound Water Hose with Male And Female QD's (used to hook your extractor to the heater)
  
• Pump Check Valve
  
• Five Foot Over Pressurized Safety Hose To Lay Back In The Sink Or Fresh Water Tank
  
• 100 Degrees C. in 2 Minutes!
  
• 2000 Watts @ 230- 240 Volts = 8.33 Amps
  
• LED indicator light
• Can Run Dry Without Instant Damage
• Double Cleaning Performance Of All Carpet And Upholstery Cleaning Equipment!
• Insulated Female QD Helps Prevent Burning Your Hand During Disconnect
  
   

When set your carpet cleaning tool down and quit cleaning, you will notice the internal water will reach 100 degrees C. and the heater will turn itself off (red lights will turn off).  When you pick up the cleaning tool or wand and start cleaning again, the heater will turn itself back on again!  The red lights will turn back on again letting you know it is working.  Average temperature rise is 7 degrees C. while cleaning (100% improvement in water molecular molecule vibration)

Please note that all electric heaters are designed to boost hot water.  They are not designed to heat cold water. You can use them with cold water, but only expect a 8-10 degree C rise while in use.

Shipping 13x13x12 in. 14bs



Questions and Answers:
Question:  Do you have to hook it to the sink to use this heater?
Answer: NO, for some reason the video was a mistake.  Just because you can hook it to the sink does noes not mean you are supposed to hook to the sink.  Most carpet cleaners would hook the machine to the carpet cleaning machine and not the sink.  The sink was only used for simulation and testing.  All in-line carpet cleaning heaters are used the same way.  You take your 5 ft solution hose (included with heater) and snap it into the outbound QD on the face of the extractor and feed the water pressure into the male QD on the Volcano 2000 heater.  Your solution hose that travels to your wand is snapped into the female QD on the heater that has insulation on it.  The over pressurization safety hose is snapped into the safety valve on one side and the open side is laid in the fresh water tank of the portable carpet cleaning machine or the sink.

Question: Will the heater break if I run it dry?
Answer:  No, the heating rods are not in the water, rather they are heating the housing.  You cannot hurt the heater by running it dry.

Question:  What happens if I let it freeze?
Answer:  I expect you will break it.  Water expanse 8% when it freezes so I am sure the housing of the heater core will break.  The housing are tested to 1500 psi but pressure in ice is way over 10,000 psi.

Question:  What is the average expected temperature rise while cleaning carpet?
Answer:  25 degree F (7 C) for carpet cleaning and 50 degrees F (10 C) for Upholstery cleaning.  Naturally the size of jets you use and the amount of squeeze / cleaning stroke time VS dry stroke time will ultimately dictate the temperature rise.


Please use 12-3 power extension cords with the heater.  See below as options.  For 220- 230 and 240 volt applications you will have to cut the USA male plug off and replace with your own that you use in your part of the world. 

Options:

Clean Storm

10-0860

Extension Power Cord 12-3 25 feet Heavy duty

Clean Storm

M1394

50 ft 12-3 Extension Power Cord 115 volt AX33

Clean Storm

SBMTray

Clean Storm: Portable Extraction Machine Drip Tray