Clean Storm 20130502, 215 PSI Pressure Switch, Blue Cap 1/4in MIP for Pressure Washers and Truckmounts

Description

The Clean Storm 20130502 215 PSI Pressure Switch with Blue Cap and 1/4" MIP connection automates burner and fuel pump operation in pressure washers and truckmounts. Engineered for reliable low-amp system control, this pressure-activated device features a 3-wire construction and a stainless steel contact pin for extended durability. Designed to operate safely in systems up to 3600 PSI and 190°F water temperatures, it ensures consistent automatic burner shutdown during bypass cycles.

Features

• Preset 215 PSI activation threshold for reliable, non-adjustable system protection.
• Durable stainless steel contact pin engineered for extended operational life.
• Versatile 3-wire construction supporting both normally open and normally closed configurations.
• Compatible with high-pressure systems rated up to 3600 PSI and 190°F maximum water temperature.
• Distinctive blue cap design for quick identification of pressure rating and specification.

Applications

• Hot water pressure washers and truckmount carpet cleaning systems.
• Automatic burner shut-off control during system bypass and idle cycles.
• Fuel pump activation and low-amp electrical accessory control.
• Industrial cleaning equipment fluid and pressure management lines.

Specifications

Cross-Reference SKUs

Tips and Additional Information

Proper installation is critical for reliable performance. Install the pressure switch in the discharge line before the pressure unloader, in the auxiliary unloader port, or in the port opposite the unloader within a dual-discharge ported manifold. Ensure correct thread sealing using appropriate thread sealant tape to prevent leaks without over-tightening into the manifold. Inspect wiring harnesses and connections regularly for corrosion or looseness, and verify that system operating pressure and water temperature remain within the specified 3600 PSI and 190°F limits.

Frequently Asked Questions

Q: How is this pressure switch wired out of the box?
A: It is wired normally open utilizing the red and tan wires from its 3-wire construction.

Q: Can the 215 PSI pressure setting be adjusted?
A: No, this unit features a preset, non-adjustable pressure setting for consistent, tamper-proof system protection.

Q: Where should the pressure switch be mounted on a truckmount or pressure washer?
A: It should be installed in the discharge line before the pressure unloader, in an auxiliary unloader port, or in the port opposite the unloader on dual discharge manifolds.

Warranty & Safety Information

This product is backed by standard manufacturer defect coverage. Warranty protection is voided if the switch is operated above maximum ratings (3600 PSI system pressure or 190°F water temperature), subjected to improper electrical wiring, damaged by thread over-torque during installation, or exposed to chemical scaling/contamination. Always disconnect system power and relieve water pressure before servicing or replacing electrical components.