

Husqvarna 588768901 Blade Shaft Drive Belt – 16PK765, 16 Rib, 765mm
Husqvarna Part Number: 588768901
Replaces Previous Part Number: 504068301
Belt Designation: 16PK765
GTIN / UPC: 805544248761
The Husqvarna 588768901 blade shaft drive belt is a 16-rib, multi-groove belt used in select Husqvarna walk-behind concrete floor saws. This belt transfers engine power to the blade shaft, providing the drive needed for concrete and asphalt cutting applications.
Previously identified as Husqvarna 504068301, this replacement belt is manufactured to the 16PK765 belt specification and is used in select Husqvarna FS 413, FS 513, FS 520, and FS 524 floor saw configurations.
Product Specifications
| Manufacturer |
Husqvarna Construction |
| Part Number |
588768901 |
| Previous Part Number |
504068301 |
| Part Description |
Blade Shaft Drive Belt |
| Belt Designation |
16PK765 |
| Belt Type |
Multi-Ribbed Poly-V Drive Belt |
| Number of Ribs |
16 |
| Nominal Belt Length |
765 mm / Approximately 30.12 Inches |
| Application |
Concrete Floor Saw Blade Shaft Drive |
| GTIN / UPC |
805544248761 |
Husqvarna Floor Saw Applications
Husqvarna 588768901 / 504068301 is listed for use in select configurations of the following walk-behind concrete saws:
- Husqvarna FS 413 Floor Saw
- Husqvarna FS 513 Floor Saw
- Husqvarna FS 520 Floor Saw
- Husqvarna FS 524 Floor Saw
Important: Blade shaft belt requirements can vary depending on the machine serial number, production year, blade diameter, and drive configuration. Not every version of the models listed above uses this belt. Verify the required part number using the equipment parts diagram before ordering.
Replacement Part Numbers and Cross References
- 588768901 – Current Husqvarna OEM Part Number
- 504068301 – Previous Husqvarna OEM Part Number
- 504 06 83-01 – Alternate Husqvarna Part Number Format
- 16PK765 – Belt Size / Industry Designation
These references are provided to assist with identifying replacement belts. Aftermarket alternatives are manufactured by independent suppliers and are not necessarily genuine Husqvarna products.
Blade Shaft Belt Replacement and Maintenance
A worn or damaged blade shaft drive belt can cause reduced cutting performance, belt slippage, excessive vibration, or loss of power transmission to the saw blade.
During routine maintenance, inspect the drive belt for:
- Cracking, splitting, or deterioration of the belt ribs
- Fraying or excessive wear along the belt edges
- Glazing, slipping, or unusual belt noise
- Uneven wear caused by pulley misalignment
- Damage from excessive heat or improper belt tension
When replacing the belt, inspect the pulleys and associated drive components. Follow the equipment manufacturer's service instructions for belt installation, alignment, and tension adjustment.
Additional Product Information
This listing is for the Husqvarna 588768901 blade shaft drive belt, which supersedes the earlier Husqvarna 504068301 part number.
The 16PK765 designation identifies the belt's multi-rib profile, 16-rib configuration, and nominal 765 mm length.
Ordering Note: Order by manufacturer part number rather than product image. Manufacturer reserves the right to change product specifications, appearance, packaging, or color without notice.
Specification
| Article gross weight |
184 g |
| Packaging width |
300 mm |
| Packaging length |
57 mm |
| Packaging height |
155 mm |
|