Pumptec 0112-0504-0001 Black Manifold for 112 and 113 Pumps with Four 1/4-Inch FIP Water Ports—No Regulator

Replace the manifold on compatible Pumptec 112 and 113 series pumps while retaining flexible plumbing options. The Pumptec 0112-0504-0001 is a genuine Pumptec replacement manifold finished in black Hadcoat and equipped with four 1/4-inch female pipe-thread water ports. This manifold is supplied without a pressure regulator so the pump can be plumbed with the regulator or pressure-control arrangement required by the equipment manufacturer.

Manufacturer: Pumptec 
Manufacturer Part Number: 0112-0504-0001
Product Type: Replacement pump manifold
Pump Compatibility: Pumptec 112 and 113 series pumps
Finish: Black Hadcoat
Water Ports: Four 1/4-inch FIP ports
Regulator: Not included
 

Four 1/4-Inch Female Pipe Ports

The quad-port design provides four 1/4-inch female pipe-thread connections for configuring the pump's inlet, outlet and related plumbing according to the original equipment layout. Unused ports must be sealed with correctly rated pipe plugs, and all fittings must be installed in the proper locations for the specific pump and machine.

FIP means female iron pipe thread. In this application, the ports accept compatible 1/4-inch male pipe-thread fittings. Do not confuse the 1/4-inch pipe-thread size with the physical diameter of the threaded opening.

Black Hadcoat Finish

This version is identified by Pumptec as the black Hadcoat manifold. Match the complete part number, finish, pump series and port configuration before ordering because similar-looking Pumptec manifolds may use a different port arrangement, finish or regulator configuration.

No Regulator Included

This listing is for the manifold only and does not include a pressure regulator. A compatible regulator or other pressure-control device may be required as part of the complete pump system. Reuse or purchase the correct components specified for your machine rather than selecting them by appearance alone.

Product Specifications

What Is Included?

• One Pumptec 0112-0504-0001 black Hadcoat manifold

Not included: Pump, motor, regulator, pressure gauge, hoses, pipe fittings, port plugs, mounting hardware and installation labor unless specifically stated elsewhere in the offer.

Ordering and Fitment Notice

Pump components that look alike are not necessarily interchangeable. Before ordering, confirm the existing Pumptec pump model, manifold part number, four-port configuration and 1/4-inch female pipe-thread connections. Compatibility with a Pumptec 112 or 113 series pump does not by itself confirm compatibility with every machine that uses one of those pumps.

Installation Information

• Disconnect electrical power and relieve all system pressure before service.
• Record the original hose, fitting and regulator locations before removing the old manifold.
• Inspect mating surfaces and replace worn seals or related service parts as required.
• Use a thread sealant compatible with the pumped liquid and system operating conditions.
• Do not overtighten pipe fittings or use the manifold as leverage during assembly.
• Prime the pump and check every connection for leakage before returning the machine to service.

Professional installation is recommended. The completed system's allowable pressure, temperature and chemical compatibility are determined by the pump model and the lowest-rated component in the assembled system.

Important

Main Four-Port Pump Manifold: The Pumptec 0112-0504-0001 is the main black Hadcoat manifold used in the fluid end of compatible Pumptec 112 and 113 series pumps. It contains the four 1/4-inch female pipe-thread water ports and mounts over the pump's valve and head assemblies.

This is not a complete pump head assembly. The two separate pump heads—sometimes referred to as end caps—as well as the plunger, valves, seals, O-rings, retaining plates, regulator, fittings and mounting hardware are not included unless specifically stated elsewhere in the offer.