Dri-Eaz 122846 Blower Retrofit Kit for DrizAir 1200 F203-A Dehumidifier

Genuine Dri-Eaz replacement 115-volt blower motor and fan retrofit kit for the Dri-Eaz DrizAir 1200 professional dehumidifier. Current manufacturer part number 122846 replaces older blower assembly numbers 102564 and 08-00257.

Product Description

Restore proper airflow through your Dri-Eaz DrizAir 1200 dehumidifier with this replacement blower retrofit kit. The blower moves air across the evaporator and condenser coils, allowing the machine to remove moisture efficiently and discharge processed air.

This kit is intended for service technicians and equipment owners repairing a DrizAir 1200 with a failed, noisy, seized, damaged, or electrically defective blower assembly.

Part Number Cross-Reference

Equipment Compatibility

Legacy Motor Label Specifications

Older versions of this blower assembly have been identified with the following motor-label information. Specifications and construction of the current retrofit kit may differ:

• 115 volts
• 60 Hz
• Approximately 1.76 amps
• Approximately 1,550 RPM
• Thermally protected
• Class B insulation

What You Receive

• One Dri-Eaz blower retrofit kit
• Current manufacturer-supplied replacement for part number 122846
• Components supplied by the manufacturer for the current production version

Only the items included by the manufacturer with the current kit are supplied. Reuse of certain original screws, fasteners, wiring retainers, insulation, or mounting hardware may be required.

Common Symptoms of a Blower Problem

• Blower does not start when the dehumidifier is operating
• Reduced airflow from the machine
• Grinding, squealing, rattling, or bearing noise
• Blower wheel rubs or does not rotate freely
• Motor overheats or stops after operating briefly
• Unit runs but produces poor drying performance due to restricted airflow

These symptoms can also be caused by damaged wiring, a control-board problem, an obstructed blower wheel, dirty coils, a damaged capacitor where applicable, or another electrical fault. Proper troubleshooting is recommended before ordering.

Installation Notice

Because this is a retrofit assembly, the current replacement may not look exactly like the original motor and fan assembly. Follow any instructions included with the kit and transfer or reuse original components only when directed or when required by the machine configuration.

Frequently Asked Questions 

Does part 122846 replace Dri-Eaz 102564?
Yes. Part number 122846 is the current retrofit replacement commonly identified for the older 102564 blower assembly.

Does it also replace 08-00257?
Yes. The original 08-00257 number was superseded by 102564, which was later superseded by the current 122846 retrofit kit.

Will the replacement look exactly like my original blower?
Not necessarily. Manufacturers may revise motors, wiring, connectors, mounting brackets, fan wheels, or included hardware while maintaining the intended replacement application.

Does this fit every Dri-Eaz dehumidifier?
No. This listing is specifically intended for compatible DrizAir 1200 F203 and F203-A applications. Do not order solely because another Dri-Eaz machine uses a 115-volt blower.

Can electrical parts be returned after installation?
Electrical components should be inspected and verified before installation. Installed, wired, modified, or energized electrical parts are generally not considered new and unused.

Ordering Checklist

• Confirm the machine is a Dri-Eaz DrizAir 1200.
• Confirm model F203 or F203-A where applicable.
• Compare your original number with 08-00257, 102564, or 122846.
• Inspect the existing wiring and mounting arrangement.
• Have the machine serial number available if additional verification is needed.

Dri-Eaz and DrizAir are trademarks of their respective owner. Steam-Brite is an independent equipment and replacement-parts supplier. Specifications and part-number information are subject to manufacturer revision without notice.